Filter
Top Products
SKU 91957 For technical questions, please call 1-800-444-3353. Page 7
Assembly/ Operation
Your Heavy Duty Ultrasonic Cleaner comes completely assembled. It is important that you read the
entire manual to become familiar with the product BEFORE you use the Ultrasonic Cleaner. Before
using the Ultrasonic Cleaner be sure that you have all parts described in the Parts List and
Assembly Diagram located on the last pages of this manual.
USE WATER OR A WATER/SOAP SOLUTION TO CLEAN OBJECTS IN THE
ULTRASONIC CLEANER. FAILURE TO FILL THE ULTRASONIC CLEANER WITH
WATER OR A WATER/SOAP SOLUTION BEFORE USING WILL SEVERELY DAMAGE
IT AND VOID THE WARRANTY.
1. Make certain that the Cleaner ON/OFF Switch is in the “OFF” position. Make certain that the
Cleaner is unplugged.
2. Fill the tank to the fill line with water or water/soap solution - see Figure 1. Use water that is
lukewarm. Excessively hot fluid will damage the Transducer (7).
3. Set the grill in the bottom of the Tank, then place the item(s) to be cleaned on the grill. (Do
not place items directly on hte Tank bottom, this may damage the transducers.)
11. Do not use penetrating oils in the Cleaner as they may damage the Cleaner and any
materials being cleaned.
12. Do not overfill the Cleaner. Use water only to the fill line when filling the tank.
13. Do not clean multiple objects at a time. Using many objects in the tank at one time
will cause them to bang against one another, damaging both the articles being
cleaned and the tank.
14. Use only lukewarm water. Excessively hot water will damage the transducer.
15. Never use a cleaning agent that would bubble or suds up over the edge of the
cleaning tank.
WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into
this product, but must be supplied by the operator.
Revised 07f