Filter
Top Products
SKU 45416 Page 5 REV 04/02
MOUNTING PLATE
FOR
GENERATOR / ALTERNATOR 10KW
SKU 45416
A mounting plate (not included), similar to the one illustrated below, will need to be provided by the
customer to properly and safely mount and operate the generator/alternator. The plate is needed to
properly tension the drive belt used to drive generator/alternator. Drawing below is for reference only
and customer may need to make further modification to mounting plate and their generator frame for
the proper and safe mounting of the generator/alternator. The drawing gives dimensions for the plate
and generator/alternator footprint.
THE MANUFACTURE AND OR DISTRIBUTOR HAS PROVIDED THE MOUNTING PLATE DIAGRAM AS A
REFERENCE TOOL ONLY. THE CUSTOMER CAN CHOOSE TO DESIGN, MANUFACTURE AND USE THEIR
OWN MOUNTING PLATE. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER
MANUFACTURING OF A MOUNTING PLATE THAT IS NOT INSTALLED PROPERLY AND SAFELY
MANUFACTURED.
DRAWING NOT TO SCALE, FOR REFERENCE ONLY !!
Note: Performance of this tool may vary depending on variations of the power driver motor.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
Material: 1/2” steel plate