Filter
Top Products
Page 9SKU 02810 For technical questions, please call 1-800-444-3353.
To Start The Chain Saw:
1. Make sure the On/Off Trigger (25b) is in its “OFF” position. (See Figure E.)
2. Plug the Electric Cord (23) into a grounded, 120 volt, electrical outlet.
(See Figure E.)
3. Use both hands to firmly grasp the handle portion of the Motor Housing Handle (1)
and Handle (47). (See Figure E.)
4. Before starting the Chain Saw, make sure nothing is in contact with the Chain (57).
(See Figure E.)
5. Make sure the Protect Plate (17) is pulled back towards your body until it “clicks”
and locks in place. (See Figure E.)
6. To start the Chain Saw, push the Safety Switch on the On/Off Trigger (25b) and
squeeze the On/Off Trigger. (See Figure E.)
7. Release the On/Off Trigger (25b) to stop the Chain Saw. WARNING: Firmly hold the
Chain Saw with both hands until the Chain Saw completely stops. (See Figure E.)
PROTECT PLATE (17) HANDLE (47)
ELECTRIC
CORD (23)
CARBON BRUSH (4)
CARBON BRUSH HOLDER (5)
CARBON BRUSH HOUSING (6)
ON/OFF TRIGGER (25b)
FIGURE E
CHAIN (57)
OPERATING INSTRUCTIONS
The Safety Brake:
1. The Safety Brake is activated when the back of the operator’s hand pushes against
the back of the Protect Plate (17). When activated, the Chain Saw will stop auto-
matically, and the On/Off Trigger (25b) should be manually released. Next, pull the
Protect Plate (17) back to its initial position in order to restart the Chain Saw.
NOTE: If the Protect Plate (17) is
not
pulled back to its initial position, the Chain Saw will
not operate. (See Figure E.)
2. To check for proper operation of the Safety Brake, disconnect the Chain Saw from
its electrical power outlet and push the Protect Plate (17) forward. Pull on the Chain
(57) with your hand protected by heavy work gloves. The Chain Saw should be
automatically locked in its “OFF” mode.