Filter
Top Products
Rev. 8 ML 8 Eclipse™ RGB User Manual
Laser Compliance Statement
This laser product complies with EN/IEC 60825-1 Ed 2, 2007-03.
Safety Notes
This device was shipped in perfect condition. In
order to maintain this condition and to
ensure safe operation, follow the safety instructions and warning notes written in this
manual. Every person involved with installation and maintenance of this device has to:
Be qualified.
Follow the instructions in this manual.
CAUTION! Be careful when operating. DO NOT touch the housing or
wires when the product is on to avoid a dangerous electric shock!
Important! CHAUVET® will not accept liability for any resulting damage caused by the
non-observance of this manual or any unauthorized modification to the device. Any
modifications to the product will void any warranty.
This product is not intended for permanent installation.
DO NOT mount this product within 50 cm of surrounding walls or large obstacles to
allow for ventilation.
Never let the power-cord come into contact with other cables! Handle the power-cord
and all connections with the mains with particular caution!
Make sure that the available voltage is not higher than stated on the rear panel.
Make sure that the power-switch is set to off-position before you connect the device
to the mains. Make sure the power plug is accessible after mounting the device.
Make sure that the power-cord is never crimped or damaged by sharp edges. Check
the device and the power-cord from time to time.
Always disconnect from power before cleaning or changing the fuse.
Never disconnect from power by tugging on the power cord.
It is essential to connect the yellow/green conductor to a ground (earth).
DO NOT attempt any repairs. The electric connection, repairs, and servicing must be
carried out by a certified technician.
Do not switch the fixture on and off in short intervals as this will reduce the laser diode
life.
Use fuses of same type and rating only.
The ambient temperature must be between 10°C to 40°C. Do not operate at
temperatures outside this range.
If the product has been exposed to drastic temperature fluctuations, do not switch it
on immediately. The arising water condensation might damage the product. Leave
the device switched off until it has reached the ambient temperature.
Do not shake the device. Avoid brute force when mounting or operating the product.
When choosing the mounting location, make sure the product is not exposed to
extreme heat, moisture, or dust.
Keep cables clear of vehicles and people. Otherwise you endanger your own and the
safety of others!
ALWAYS use a safety cable attached to the safety eye hook when mounting the
product overhead.
Use the original packaging when transporting.
Unauthorized modifications are forbidden for safety reasons!
CAUTION! Operate the device only after having familiarized yourself with its
functions. Do not permit operation by unqualified persons. Most damages are the
result of unprofessional operation.
CAUTION! DO NOT operate this device in ways not specified in this User Manual.
Failure to follow the guidance in this manual will void the warranty, may damage the
product, and injure the user or the audience.