Legend™ 550 Spot User Manual 23 1/11/2010 11:36 AM
Setting the DMX starting address
This DMX mode enables the use of a universal DMX controller device. Each fixture requires a "start address"
from 1 ~ 512. A fixture requiring one or more channels for control begins to read the data on the channel
indicated by the start address. For example, a fixture that uses 6 DMX channels and was addressed to start on
DMX channel 100, would read data from channels: 100, 101, 102, 103, 104, and 105. Choose start addresses
so that the channels used do not overlap, and note the start address selected for future reference.
If this is your first time addressing a fixture using the DMX control protocol, we suggest jumping to the
“Appendix” section and reading the heading “DMX Primer”. It contains very useful information that will help you
understand its use.
Legend™ 550 Troubleshooting
Symptom Solution(s)
Auto shut off Check fan thermal switch reset
Beam is very dim or not bright
Clean optical system or replace lamp
Check voltage switch for proper setting
Breaker/Fuse keeps blowing Check total load placed on device
Device has no power
Check for power on Mains.
Check device’s fuse. (internal and/or external)
Fixture is not responding
Check Display settings for correct addressing
Check DMX cables
Lamps cuts off sporadically
Possible bad lamp or fixture is overheating.
Lamp may be at end of its life.
Light will not come on after power
failure
Discharge lamps require a cooling off period before the electronics in the
fixture can kick start it again, wait 5 ~ 10 minutes before powering up.
Loss of signal
Use only DMX cables
Install terminator
Note: Keep DMX cables separated from power cables or black lights.
Moves slowly Check FasTap™
No light output Check lamp
Stand alone mode This fixture features stand-alone functions. See “Menu Map” for details.
If you still have a problem after trying the above solutions, please contact CHAUVET Technical
Support at the location listed below.
Technical Support
Address: Service Dept.
3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.)
Support (Email): tech@chauvetlighting.com
Telephone: (954) 929-1115 - (Press 4)
Fax: (954) 929-5560 - (Attention: Service)
Website: http://www.chauvetlighting.com