Filter
Top Products
Setup
Q-Spot™ 460-LED User Manual Rev. 5 7
DMX Linking
You can link the Q-Spot™ 460-LED to a DMX controller using a standard DMX serial
connection. If using other DMX compatible products with the Q-Spot™ 460-LED
, you
can control each individually with a single DMX controller.
DMX Modes
The Q-Spot™ 460-LED uses the standard DMX data connection for the 11 and 14
channel DMX modes.
· Refer to the Introduction chapter for a brief description of these modes.
· Refer to the Operation chapter to learn how to configure the Q-Spot™ 460-LED to
work in these modes.
· The DMX Values section will provide you with detailed information regarding the DMX
modes.
Master/Slave
Connectivity
The Master/Slave mode allows a Q-Spot™ 460-LED (the “master product”) to control
one or more Q-Spot™ 460-LEDs (the “slave products”) without a DMX controller. One Q-
Spot™ 460-LED
becomes the master product when running an Auto or Custom
program.
You must configure each slave product’s control p
anel to operate in SLAVE mode.
During Master/Slave operation, the slave products will operate in unison with the master
product.
DO NOT connect a DMX controller to products operating in Master/Slave mode.
The DMX controller signals may interfere with th
e signals from the master
product.
The Operation chapter of this manual provides detailed instructions on how to
configure the Master and Slave products.
If you are not familiar with or need more information about DMX standards,
Master/Slave connectivity, or the DMX cables needed to link this product to a DMX
controller, download the DMX Primer from the CHAUVET® website:
www.chauvetpro.com.