Filter
Top Products
Page 4 of 15 SlimPAR™ 38 User Manual Rev. 3
Safety Instructions
· Please keep this User Manual for future consultation. If you sell the unit to another
user, be sure that they also receive this instruction booklet.
· Always make sure that you are connecting to the proper voltage, and that the line
voltage you are connecting to is not higher than that stated on the decal or rear panel
of the fixture.
· This product is intended for indoor use only! To prevent risk of fire or shock, do not
expose fixture to rain or moisture.
· Make sure there are no flammable materials close to the unit while operating.
· The unit must be installed in a location with adequate ventilation, at least 20 in (50 cm)
from adjacent surfaces. Be sure that no ventilation slots are blocked.
· Always disconnect from power source before servicing or replacing fuse and be sure to
replace with same fuse source.
· Secure fixture to fastening device using a safety chain.
· Maximum ambient temperature (Ta) is 104° F (40° C). Do not operate fixture at
temperatures higher than this.
· In the event of a serious operating problem, stop using the unit immediately. Never try
to repair the unit by yourself. Repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest authorized technical assistance
center.
· Never connect the device to a dimmer pack.
· Make sure the power cord is never crimped or damaged.
· Never disconnect the power cord by pulling or tugging on the cord.
· Never carry the fixture directly from the cord. Always use the hanging/mounting
bracket.
· Avoid direct eye exposure to the light source while it is on.
Please read these instructions carefully. It includes important information
about the installation, usage and maintenance of this product.