Filter
Top Products
SlimPAR™ 38 User Manual Rev. 3 Page 11 of 15
Standalone Operation
Automatic
This fixture has preprogrammed chases. These are accessed via the control panel. The speed
may be adjusted for the chases. Please see the instructions below for further explanation.
1. Press <MENU> until P-- appears on the LED screen.
2. Press <ENTER>.
3. Using <UP> and <DOWN>, select the desired program (
P1~P4).
4. Press <ENTER>.
5. Press <MENU> until
S-- appears on the LED screen.
6. Using <UP> and <DOWN>, select the desired program speed (
S001~S100).
7. Press <ENTER> to confirm settings.
Sound-Active
This fixture has preprogrammed sound triggered chases. These are accessed via the control
panel. The microphone sensitivity may be adjusted using the audio adjustment knob. Please see
the instructions below for further explanation.
1. Press <MENU> until P-- appears on the LED screen.
2. Press <ENTER>.
3. Using <UP> and <DOWN>, select the desired program (
P5~P6).
4. Press <ENTER> to confirm settings.
Preset Colors
This fixture has preprogrammed static color presets. These are accessed via the control panel.
Please see the instructions below for further explanation.
1. Press <MENU> until C-- appears on the LED screen.
2. Press <ENTER>.
3. Using <UP> and <DOWN>, select the desired color preset (
C1~C7).
4. Press <ENTER> to confirm settings.
Custom Static Colors
This fixture has the ability to accept custom static color settings. These are accessed via the
control panel. Please see the instructions below for further explanation.
1. Press <MENU> until U-- appears on the LED screen.
2. Press <ENTER>.
3. Using <UP> and <DOWN>, select the desired color (
r, G, b).
4. Press <ENTER>.
5. Using <UP> and <DOWN>, select the desired color value (
000~100). By selecting 000,
the color will remain off.
6. Press <ENTER> to continue to the next color (
r, G, b).
7. Using <UP> and <DOWN>, select the desired color value (
000~100). By selecting 000,
the color will remain off.
8. Repeat steps 6 & 7 until the desired color is obtained. Press <ENTER> to save the final
color setting. This will move the selection to the following color; however, this is necessary
to save the modification.
The colors are represented by the following in the menu map:
r--- = Red (000~100)
G--- = Green (000~100)
b--- = Blue (000~100)