Filter
Top Products
Arena™ 2100 Flex User Manual (Rev. 7) Page 9 of 13
4. OPERATION
To access the control panel functions, use the four buttons located underneath the
display.
Control
Panel
Operation
Button Function
<FUNCTION> Press to find an operation mode or to back out of the current menu
<UP>
Press to scroll up the list of options or to find a higher value
<DOWN>
Press to scroll down the list of options or to find a lower value
<TIMER>
Turns on Timer Mode
<VOLUME> Turns on Volume Mode
<MANUAL> Controls fog output manually
Menu Map
Mode Programming Steps Description
Interval Set
1~200
Adjusts the fog output interval (in seconds)
Duration Set 1~200 Adjusts the fog output interval (in seconds)
Timer Out
1~100%
Adjusts the fog output volume of Timer Mode
Volume Out
1~100%
Adjusts the fog output volume of Volume Mode
DMX 512 Add 1~512 Sets the DMX address
Wireless On On Off Turns the wireless function on or off
Configuration
(DMX)
Set this product in DMX mode to control with a DMX controller.
When connected to
DMX, the fogger will operate in an off-on mode at whatever settings were set through
the control panel.
1. Connect this product to a suitable power outlet.
2. Turn this product on.
3. Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket of this product.
Starting Address
The Arena™ 2100 Flex uses one DMX channel in its 1-Channel DMX mode, which
defines the highest configurable address to 512.
If you are unfamiliar with DMX,
download the DMX Primer from www.chauvetlighting.com.
To select the starting address, do the following:
1. Press <FUNCTION> repeatedly until DMX 512 Add shows on the display.
2. Use <UP> or <DOWN> to select the starting address.
Configuration
(Standalone)
Set this product in one of the standalone modes to control without a DMX controller.
1. Connect this product to a suitable power outlet.
2. Turn this product on.
Never connect a product
that is operating in any standalone mode, whether
Static, Automatic, or Sound to a DMX string connected to a DMX controller. This
is because products in standalone
mode may transmit DMX signals that could
interfere with the DMX signals from the controller.
Timer Mode
To enable the Timer mode, do the following:
1. Connect this product to a suitable power outlet.
2. Turn this product on.
3. Press <FUNCTION> repeatedly until Interval Set shows on the display.
4. Use <UP> or <DOWN> to select the time in between haze.
5. Press <FUNCTION> repeatedly until Duration Set shows on the display.