Filter
Top Products
4
Resetting Weather Conditions: If the weather forecast deviates from the existing conditions
after the initial setup, you can change the weather offset in this manner:
1. Hold the "CLEAR" button for 3 seconds to enter the pressure offset mode. The weather icon
will flash.
2. Select the existing weather condition by pressing "MIN/MAX."
3. Press "CLEAR" to confirm your selection and exit the setting mode.
Selecting Celsius/ Fahrenheit display on home unit:
Hold "MIN/MAX" button 3 seconds to select C or F.
WEATHER FORECAST with Storm Alert:
The built-in precision Barometric pressure sensor will read the atmospheric pressure and
calculate the weather conditions for the next 12 hours.
The Icons will show:
Sunny Partial Sunny Cloudy Rainy Stormy (Flash) Icy
Pressure, Temperature, Humidity Trend Indicators:
Small arrow icons displayed in boxes will indicate: Rising( ), Steady( ), Falling( ).
Refresh rate is once every hour.
Moon Phase:
Moon Phase is shown by the scrolling of the moon icon from left to right. The icon will stop at the
existing moon phase for 5 seconds and then resume scrolling.
Manually Adjusting Clock & Calendar Setting:
Hold the "SET" button for 3 seconds to enter the clock setting mode. Using "+" or "-" to adjust and
"SET" to confirm, the following values can be set in sequence: 12/ 24 hr > Year > Month > Date
> Hour > Minutes > DST on/ off. Turning DST off disables the Daylight Saving Time setting.
ADDITIONAL FEATURES
Using ALARM 1( ), ALARM 2( ):
This unit has two alarms that can be set independently of one another. Select ALARM 1 or ALARM
2 by pressing the "ALARM" button. Hold the "ALARM" button for 3 seconds. Press "+" or "-" to
enter the desired alarm time and press "ALARM" to confirm the setting. Please be sure to note the
PM indicator to ensure you have set the alarm for the proper time.
To view alarm time 1 and 2, simply press the "ALARM" button to read ALARM 1 and ALARM 2. The
alarm time will be displayed for 5 seconds and then revert to the normal clock display.
To turn AL 1, AL 2 on and off, press "+" button. When alarm one is set a bell with a number one
will show next to the right of the calendar. When the second alarm is set a bell with a number two
will appear to the right of the calendar. If both alarms are set, both bells will appear.
The unit will sound a Crescendo Alarm which will last for 2 minutes before turning itself off.
Pressing the "Snooze" button will repeat the alarm after 5 minutes. Use the "ALARM" button to
turn the alarm off completely.
Low Battery Indicator:
A low battery indicator is shown on the main unit display panel for the home unit itself and all of
the remote channels. Replace the batteries and follow the setup procedure as mentioned in this
instruction manual.
2
1