Filter
Top Products
12
2. Locate the square dovetail bracket that has the proper curvature for the NexStar tube and align the holes
with the two holes in the telescope body.
3. Use the two 8-32 x ¼" screws to tighten down the bracket to the rear cell.
4. Once the bracket is mounted, slide the mounting track at the bottom of the Star Pointer over the dovetail
portion of the bracket. It may be necessary to loosen the two screws on the side of the mounting track
before sliding it over the dovetail. The end of the Star Pointer with the glass window should be facing out
towards the front of the telescope.
5. Tighten the two screws on the side of the mounting track to secure the Star Pointer to the dovetail bracket.
Star Pointer Operation
The star pointer is powered by a long life 3-volt lithium battery (#CR2032) located underneath the front portion of
the Star Pointer. Like all finderscopes, the Star Pointer must be properly aligned with the main telescope before
it can be used. This is a simple process using the azimuth and altitude control knobs located on the side and
bottom of the Star Pointer. The alignment procedure is best done at night since the LED dot will be difficult to
see during the day.
1. To turn on the Star Pointer, rotate the variable brightness control (see figure 1-5) clockwise until you here a
"click". To increase the brightness level of the red dot, continue rotating the control knob about 180º until it
stops.
2. Locate a bright star or planet and center it in a low power eyepiece in the main telescope.
3. With both eyes open, look through the glass window at the alignment star.
If the Star Pointer is perfectly aligned, you will see the red LED dot overlap the alignment star. If the Star Pointer
is not aligned, take notice of where the red dot is relative to the bright star.
4. Without moving the main telescope, turn the Star Pointer's azimuth and altitude alignment controls until the
red dot is directly over the alignment star.
If the LED dot is brighter than the alignment star, it may make it difficult to see the star. Turn the variable
brightness control counterclockwise until the red dot is the same brightness as the alignment star. This will make
it easier to get an accurate alignment. The Star Pointer is now ready to be used . Remember to always turn
the power off after you have found an object. This will extend the life of both the battery and the LED.