Filter
Top Products
28 SEBU7858-03
Safety Section
Operation
Note: The shade
d areas indicate the approximate
location of areas with significant restricted visibility.
There is restricted visibility to the area directly be-
hind the mach
ine. Failure to make sure the area is
clear could result in injury or death. Use a second
person on the ground to make sure that the area
is clear bef
ore you operate the machine in the RE-
VERSE position. Refer to the Operation and Main-
tenance Manual, “Operation Information” for more
informatio
n.
i03565616
Operation
SMCS Code: 7000
Machine Operating Temp erature
Range
The stan
dard machine configuration is intended
for use within an ambient temperature range
of −40 °C (−40 °F) to 50 °C (122 °F). Special
configur
ations for different ambient temperatures
may be available. Consult your Caterpillar dealer for
additional information on special configurations of
your ma
chine.
Machin
eOperation
Only operate the machine while you are in a seat.
The se
at belt must be fastened while you operate the
machine. Only operate the controls while the engine
is running.
While you operate the machine slowly in an open
area, check for proper operation of all controls and all
prot
ective devices.
Before you move the machine, you must make sure
tha
t no one will be endangered.
Do not allow riders on the machine unless the
mac
hine has the following equipment:
•
additional seat
•
additional seat belt
•
Ro
llover Protective Structure (ROPS)
Never use the work tool for a work platform.
Note any needed repairs during machine operation.
Report any needed repairs.
Do not operate t
he machine on ground conditions
that could result in the seat suspension travel stops
being contacted and do not operate the machine at
travel speeds
that could result in the seat suspension
travel stops being contacted. Operating this machine
in very rough ground conditions or at travels speeds
not suitable
for the ground conditions may result
in excessive seat vertical travel with impact of the
suspension against the travel stops, which may
cause injur
y. In order to minimize impact loading on
the operator, properly adjust the seat controls for the
operator weight and height. Refer to Operation and
Maintenanc
e Manual, “Seat” for more information.
Carry attachments approximately 40 cm (15 inches)
above grou
nd level. Do not go close to the edge of a
cliff, an excavation, or an overhang.
If the mach
ine begins to sideslip downward on a
grade, immediately remove the load and turn t he
machine downhill.
Avoid any conditions that can lead to tipping the
machine. The machine can tip when you work on
hills, on
banks and on slopes. Also, the machine
can tip when you cross ditches, ridges or other
unexpected obstructions.
Avoid operating the machine across the slope. When
possible, operate the machine up the slopes and
down the
slopes.
Maintain control of the machine. Do not overload the
machin
e beyond the machine capacity.
Never straddle a wire cable. Never allow other
perso
nnel to straddle a wire cable.
Before you maneuver the machine, make sure
that n
o personnel are between the machine and
attachments.
Know
the maximum dimensions of your machine.
Always keep the Rollover Protective Structure
(ROP
S) installed during machine operation.
i02624835
Engine Stopping
SMCS Code: 1000; 7000
Do not stop the engine immediately after the
machine has been operated under load. This can
cause overheating and accelerated wear of engine
components.