Filter
Top Products
14
PRIME•TOUCH
®
rEMOTE OPEraTION
Send Signal
LED
ChaNgINg TraNSMITTEr frEqUENCY SETTINg
You will only have to change the dip switch settings in the
remote if you are using more than one fan in the same
area and want to control them separately.
Step 1. At the circuit breaker or fuse box, turn the power
off for the fan you want to change.
and remove the batteries.
Step 3. Change the dip switch settings, assuring
that they are different from the previously installed
Step 4. Replace the batteries and the battery door on
the control.
Step 5. At the circuit breaker or fuse box, turn the
power back on for the fan whose frequency you are
changing.
Step 6. Within 20 seconds of restoring power, push the
HIGH, MED, and LOW buttons (in that order).
Circuit Breaker
or Fuse Box
Press in this order to set new
frequency:
1. HIGH 2. MED 3. LOW
Dip Switch
Set to “0101”
Dip Switch
Set to “1000”
LOW
MED
HIGH
LIGHT
REVERSE
FAN
OFF
Note: You may want to label your remote controls to
assure you do not mix them up.
WARNING!
Do not turn the power off at the circuit
breaker, then back on, for a previously
installed Prime•Touch fan, asyou may
inadvertently change the frequency settings
for it as well.
Note: All fans leave the factory set to “0000.”
Fan Control
To start the fan, press the appropriate speed button to run the fan at the desired
speed.
To turn off the fan, press the FAN OFF button.
AirowDirection
REVERSE operates at
any speed, whether the fan is on or off. The fan returns to its set speed after
reversing.
Light Control
Turn the light on or off independently from the fan by pressing the LIGHT button.
If you press the button for more than 0.7 seconds, it becomes a dimmer. The
light varies from “bright” to “dim” over approximately 8 seconds. If you continue
to hold the LIGHT button, this sequence will reverse when the light reaches
the brightest or dimmest level. Release the button when the desired level is
reached.
HigH 3
med 2
low 1