Filter
Top Products
8
Screw
6-32 X 1"
(2)
Screw
6-32 X
3
/
8
"
(2)
Wood
Screw
1" (2)
Drywall
Anchor
6-32 (2)
12v Battery
W-72
Control
W-72
Control Holder
VERSA•TOUCH2® COnTROl InSTAllATIOn
COnTROl BRACkET InSTAllATIOn
Standard Light Switch
Step A. Remove the two screws holding the switch
cover plate. Do not remove the cover plate.
Step B. Orient the control bracket as shown and line
up the two inner mounting holes with those on the
switch.
Step C. Insert and tighten the screws using the
provided screwdriver.
INNER
MOUNTING
HOLES
CONTROL
BRACKET
STANDARD
TOGGLE
SWITCH
SWITCH
COVER
PLATE
Rocker Light Switch
Step A. Break off the two tabs by pushing outward.
Step B. Remove the two screws holding the switch
cover plate. Do not remove the cover plate.
Step C. Orient the control bracket as shown and line
up the two inner mounting holes with those on the
switch.
Step D. Insert and tighten the screws using the
provided screwdriver.
OUTER
MOUNTING
HOLES
CONTROL
BRACKET
ROCKER
LIGHT
SWITCH
SWITCH
COVER
PLATE
Wall Installation
Step A. Locate a 2x4
wall stud in a convenient
location.
Step B. Orient the control
bracket as shown over
the 2x4 stud.
Step C. Insert the 1" wood
screws in either the inner
or outer mounting holes
and tighten using the
provided screwdriver.
DECOR OVALHEAD SCREW
6-32 X 1"
ANCHOR
PANHEAD
SCREW
DRYWALL ANCHOR
NOTE: The wall anchors and 6-32 x 1" screws may
be used in situations where mounting to a stud is
not possible. Use the inner mounting holes. After
securing the anchor, discard the anchor’s pointed
screws and use the 6-32 decor ovalhead screws
supplied.
WOOD
SCREW 1"
(not to scale)
Step 17. Follow instructions for the type of transmitter control bracket you will be using.
SAFETY FIRST: To reduce the risk of electrical shock, this fan must be installed with an isolating wall control/
switch. CAUTION! Do not use with wall dimmer.
device. Use only the control provided with this fan.