3
Mo d e n a
®
II
INSTALLATION INSTRUCTIONS
IMPORTANT!Leavethefaninthecartonuntilyouarereadytohangthefan.
CEILING HARDWARE
GETTING STARTED
Installing a New Ceiling Fixture Outlet Box
wish to place your Casablanca fan, an approved ceiling
After turning the power OFF at its source (either circuit
that it is marked ‘Approved for ceiling fan mounting
If it is not, a new box must be installed.
Warning:
shock, or personal injury, mount to outlet box
marked acceptable for ceiling fan support using
the mounting hardware provided with the outlet
CAUTION: To reduce the risk
of personal injury, use only the
mounting hardware provided
with the approved outlet box to
install the crossbar mounting
bracket.
CROSSBAR MOUNTING BRACKET INSTALLATION
Proceedwithinstallationasfollows:
Step1. To install the crossbar mounting bracket, route
the outlet box wires along side of the crossbar mounting
bracket. Attach the crossbar mounting bracket to the
outlet box with the set of two round-head screws and
-
not to bend the bracket by over tightening.
Step2. To install the lag screw, slide the remaining
the center hole in the crossbar mounting bracket. Se-
cure the lag screw into the guide hole, tightening until
support beam.
CROSSBAR
MOUNTING
BRACKET
WIRE NUT (4)
FLAT WASHER (2)
LAG SCREW AND WASHER
(1)
1″ x 8-32 ROUND
HEAD SCREWS (2)
JOIST
CEILING FIXTURE
OUTLET BOX
(CEILING FAN
RATED)
CROSSBAR
MOUNTING
BRACKET
(RIDGE SIDE
DOWN)
1” X 8-32
ROUND-HEAD
SCREWS (2)
WASHERS
(2)
CEILING
WIRING
GREEN
GROUND
WIRE
LAG SCREW
AND
WASHER (1)