Filter
Top Products
5
CANOPY HARDWARE
CANOPY
CANOPY
HATCH
CANOPY LOCK WASHER (4)
CANOPY SCREW (4)
Step 4. To hang the fan body in the
canopy, hold the fan body firmly and in-
sert the ball into the canopy opening.
Check that no wires were pinched. Ro-
tate the fan body until the slot in the
ball fits into the pin opposite the canopy
opening.
CAPPED
BLUE
D1-OPTION
WIRE.
PIN
SLOT
BALL
CANOPY LOCK
WASHERS
CANOPY GASKET,
HANGING PLATE, &
CROSSBAR MOUNTING
BRACKET INSTALLED
CANOPY
Note: On sloped ceilings, align the
canopy opening toward the top or
room peak.
Step 3. Thread the wires from the ceiling through
the opening in the canopy gasket. Attach the
canopy to the crossbar mounting bracket with three
of the 8-32 x 2
1
/4″ long canopy screws and canopy
lock washers.
Using the screwdriver, tighten the screw firmly by
hand only.
LANAI
CANOPY
SCREWS
Step 5a. Attach the fan wires to the ceiling fixture outlet
box wiring by placing the bare ends of the wires side by side
and then securing with a wire nut. Test that the connection
is secure by pulling on the wire nut. Connect in this order:
Step 5b.
• GREEN leads from mounting plate and fan to GROUND con-
ductor of power source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceiling
fixture outlet box. Secure with wire nut.
• BLUE wire and BLACK power wire from fan to BLACK power
wire in ceiling outlet box. Secure with wire nut.
2 WHITE WIRES
2 BLACK WIRES
WIRE NUT
3 GREEN WIRES
CANOPY INSTALLATION
HANGING THE FAN
CANOPY ELECTRICAL CONNECTIONS