Filter
Top Products
3
PREPARATION INSTRUCTIONS
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them
against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
MOTOR
COUPLING
TAPERED
THREAD
MOTOR
WIRES
GROUND
WIRE
ALLEN SET
SCREW
DOWNROD
& BALL
ASSEMBLY
DOWNROD & BALL
ASSEMBLY
LANAI
DOWNROD
GASKET
DOWNROD
GASKET
Step A. Slide the downrod gasket onto the downrod as shown,
pushing the gasket so that it is snug with the ball of the
downrod.
Step E. Slide the downrod gasket down so that it fits snugly
against the motor casing as shown.
PERMA•LOCK™ HARDWARE
DOWNROD GASKET PREPARATION
FAN PREPARATION
DOWNROD GASKET PREPARATION
Prepare for fan installation as follows:
Step B. Route the wires from the motor through the
Perma
•
Lock™ downrod and ball assembly.
Step C. Using the provided allen wrench, loosen the set screw
several turns to allow installation of the downrod. Thread
the downrod into the motor coupling until it stops turning,
this will take at least four and a half full turns.
Step D. Securely tighten the set screw with the provided allen
wrench to ensure safe operation of your fan.
Tip: The downrod has a tapered thread
that is designed to lock completely when
correctly installed.
CAUTION: Failure to fully lock in the down-
rod before securely tightening the allen set
screw may cause the fan to separate from
the downrod during normal operation!
IMPORTANT SAFETY INFORMATION!
BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN, INSTALL THE
THREADED DOWNROD INTO THE MOTOR COUPLING AND LOCK THE ASSEMBLY
ALLEN SET SCREW
1
⁄4-20 x
1
⁄4"
(PRE-INSTALLED)
3mm
ALLEN WRENCH
CAUTION: Before trimming wires or
installing the downrod, pull the wires
on the bottom of the fan to assure they
are all the same length as shown.