Filter
Top Products
4
CEILING HARDWARE
CROSSBAR
MOUNTING
BRACKET
WIRE NUT (4)
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit breaker
or fuse box), lower the old fixture and disconnect the wiring.
Check the ceiling fixture outlet box to be sure that it is
marked ‘Approved for ceiling fan mounting’. If it is not, a new
box must be installed.
Warning: To reduce the risk of fire, electrical shock,
or personal injury, mount to outlet box marked
acceptable for ceiling fan support using the mount-
ing hardware provided with the outlet box.
ADDITIONAL HARDWARE
CANOPY GASKET
2
1
/4″ x 8-32 ROUNDED
HEAD SCREW (2)
FLAT WASHER (2)
1″ x 8-32 ROUNDED
HEAD SCREW (2)
HANGING PLATE
Step 1. Fit the hanging plate into the canopy gasket as shown.
Make sure that the four holes of the hanging plate align with
the four indentations on the inside of the gasket and that
the two mounting bracket screw holes align with the two
pierced marks in the canopy gasket
CAUTION: To reduce the risk of
personal injury, use only the
mounting hardware provided with
the approved outlet box to install
the crossbar mounting bracket.
CEILING
WIRING
CROSSBAR
MOUNTING
BRACKET
FLAT
WASHER
GREEN
GROUND
WIRE
CEILING FAN
APPROVED
OUTLET BOX
RIDGE
SIDE
DOWN
OUTLET BOX
MOUNTING
HARDWARE
Proceed with installation as follows:
Step 2. Route the wires from the ceiling outlet box through
the center hole of the canopy gasket and hanging plate and
then the crossbar mounting bracket center hole.
Push the mounting hardware included with the outlet box
through the pierced marks in the rubber canopy gasket so
that they align with the threaded holes of the ceiling fan
approved outlet box.
Using the screwdriver, tighten the screws firmly by hand only,
being careful not to bend the bracket by over tightening.
LANAI
CANOPY
GASKET
HANGING
PLATE
CANOPY
GASKET &
HANGING
PLATE
MOUNTING
BRACKET
SCREW HOLE
GETTING STARTED
CANOPY GASKET PREPARATION
CROSSBAR MOUNTING BRACKET INSTALLATION