Filter
Top Products
6
RUBBER GROMMET
(4 PER BLADE)
BLADE SCREW
(4 PER BLADE)
BLADE & BLADE HOLDER HARDWARE
BLADE
HOLDER
BLADE HOLDER
SCREW
(2 PER BLADE)
Step 9. Insert a rubber grommet through
each blade hole of every blade. Inspect
both sides of the blade to assure that
the lips of the grommet are fully engaged.
RUBBER GROMMET INSTALLATION
CORRECT INSTALLATION
INCORRECT INSTALLATION
Step 8. To reach the blade holder mounting
holes in the fan motor the dummy switch
housing must be removed.
Take out the two 5-32 X
9
/32” screws secur-
ing the dummy switch housing and remove.
Put the two (2) screws aside for the mo-
ment, they will be used in Step 15 to install
the switch housing after the blades are in-
stalled.
The dummy switch housing is used only when
shipping the fan.
INSTALLING THE BLADE/BLADE HOLDER TO FAN MOTOR
PREPARATION
DUMMY
SWITCH HOUSING
MOUNT SCREW
5-32 X
9
/32”
(2)
DUMMY
SWITCH
HOUSING
CAPISTRANO
™
Casablanca
Note: Save these two screws–they
will be used in Step 15!