Filter
Top Products
8
BLADE SCREW
(4 PER BLADE)
FLAT WASHER
(4 PER BLADE)
INSTALLING THE GLASS SHADE
INSTALLING THE HALOGEN BULB
Step 15. Screw the 100 Watt Halogen bulb into the socket.
Do not touch the glass bulb with your fingers–it is extremely
important that the glass be clean. If it is touched, or dirty,
clean carefully with a tissue. A dirty glass bulb will cause the
bulb to fail almost immediately.
Step 14. Blade Installation
Attach the blades to the
blade holders with four blade
screws and four steel washers
provided for each blade.
Hand tighten securely.
Step 16. Position the indentations in the outer rim of the
glass shade so that they line up with the tabs on the inside
surface of the fan light fixture rim.
Step 17. Carefully lift the glass shade up inside the light
fixture as far as it will go.
Step 18. Rotate the shade in a clockwise direction until it is
held tightly in place by the three tabs.
CENTER STYLE BLADE HOLDER & BLADE
LIGHT
FIXTURE
TABS
GLASS
SHADE
GLASS SHADE
INDENTATION
IMPORTANT! When installing the halogen bulb, care-
fully cut off the end of the plastic sleeve the bulb
comes in and hold the bulb by the plastic sleeve to
screw it into the socket.
BLADE HOLDER HARDWARE
BLADE SCREW
(4 PER BLADE)
FLAT WASHER
(4 PER BLADE)
HALOGEN BULB
100 WATT
TIP: At first the shade is a very loose fit in the fix-
ture and can be ‘wiggled’ a little from side to side.
It is a great help when rotating the glass shade to
‘wiggle’ it at the same time.
GLASS SHADE
HALOGEN BULB
100 WATT