Filter
Top Products
10
Inteli•Touch
®
The POWE button is normally left in the on position. Always turn the power
off during cleaning or servicing the fan and during thunderstorms. It is also
used to exit or enter additional programs.
POWER must be left on to retain a previously set fan speed or light
level.
There are six individual speed settings for the fan; each speed is indicated
by an audible tone of increasing pitch.
To select the desired fan speed:
1. With fan off, press and hold the button labeled . The fan blades
will start rotating at the slowest speed, and will increase in steps.
2. Release the button when the desired speed is reached.
The fan speed is now in memory and will automatically come on at the same
speed each time the button is used. To maintain this level of speed,
turn the fan on by pressing less than one second. To lower speed,
turn fan off, then on by pressing and holding the button until the
desired speed is reached. When the fan is on, you may increase the speed by
pressing and holding the button until the desired speed is reached,
then release it.
The direction of airflow can be changed from downward to
upward or from upward to downward.
To reverse the airow:
1. Make sure the is on.
2. Press the button.
Note: A four-toned signal indi-
cates the command was accepted
by the fan. A few seconds later
the fan will slow to a stop and
then reverse direction.
FAN CONTROL
ON - OFF
A momentary press of
the FAN button
TO CHANGE SPEED
Press and hold FAN
button longer than one
second
INTELI•TOUCH OPERATION
POWER
INTELI•TOUCH OPERATION
SPEED CONTROL
INTELI•TOUCH
•
REVERSING AIRFLOW
FAN
FAN
FAN
FAN
FAN
FAN
FAN
REVERSE
INTELI•TOUCH OPERATION • LIGHT
LIGHT CONTROL
CYCLES THROUGH SE-
QUENCE:
1. Both lights come on
2. Down light only
3. Up light only
To turn the lights off and on, press and release the button for less
than one second.
The sequence is, when the power is on:
First touch of the light button—both lights come on
Second touch of the light button—down light only
Third touch of the light button—up light only
To vary the light brightness at each touch level:
Make sure where you are in the sequence to the right.
To dim both lights at the same time:
1. Make sure you have the uplight on.
2. Turn the light off, then press and hold the button. After one
second, both lights will come on at their lowest setting and gradually
become brighter.
3. Release the button when the desired brightness is reached.
To dim just the up light:
1. Make sure you have just the downlight on.
2. Turn the light off, then press and hold the button. After one
second, the up light will come on at the lowest setting and gradually
become brighter.
3. Release the button when the desired brightness is reached.
To dim just the down light:
1. Make sure you have both lights on.
2. Turn the light off, then press and hold the button. After one
second, the down light will come on at the lowest setting and gradually
become brighter.
3. Release the button when the desired brightness is reached.
POWER
LIGHT
LIGHT
LIGHT
LIGHT
LIGHT
LIGHT
LIGHT