Filter
Top Products
6
INSTALLING THE UPPER GLASS SHADE
UPPER
GLASS
SHADE
BRACKET
NOTE: Make a note of the
Fan Serial Number and
Model Type before install-
ing the top cover.
Step 5. Carefully place the upper
glass shade on the foam covered
brackets. Assure the glass sits
evenly on the bracets and is
centered.
Step 6. Take the three upper
glass shade brackets and place
them in the holders as shown.
Using the supplied screws, tight-
en a few turns on each bracket
until all three are in place. DO
NOT TIGHTEN COMPLETELY.
Step 7. Rotate the tightening of
the brackets until all are snug.
DO NOT OVERTIGHTEN.
IMPORTANT! To avoid possible damage to the
Halogen bulb holder the fan must be placed on
the bottom styrofoam packaging from the box.
After removing the top half of the styrofoam,
take the bottom half from the box and place it
on the floor. Take out all parts from the bottom
foam and place the fan back in the form fitted
recess.
FAN MOTOR
ASSEMBLY
UPPER AND LOWER GLASS PARTS
GLASS SHADE
HALOGEN BULB
100 WATT
UPPER
GLASS
SHADE
UPPER GLASS
SHADE BRACKET
(3)
UPPER
GLASS
SHADE
INCANDESCENT BULB
60-WATT (3)
FOAM
COVERED
BRACKET
INSTALLING THE UPPER GLASS SHADE
Step 8. Istall the three 60-Watt
frosted incandescent bulbs as
shown.
Note: Use 3 maximum 60-Watt B10
candelabra incandescent bulbs.
WARNING!
DO NOT USE AN ELECTRIC SCREWDRIVER AS
YOU MAY ACCIDENTALLY OVETIGHTEN THE
BRACKETS AND CAUSE THE GLASS TO BREAK.