Filter
Top Products
7
TILT THE FAN TO
INSTALL LAST
CANOPY SCREW
BULB INSTALLATION
CANOPY HATCH INSTALLATION
CANOPY
CANOPY
LOCK
WASHER
CANOPY
SCREW
Step 6. Tuck the wires into the canopy with the wire nuts
pointed upwards, so that the white and black wires are on
opposite sides of the canopy and all wires are clear of the
canopy opening.
Step 7. Install canopy hatch with the last canopy screw
and lock washer. To do this, tilt the fan body away from the
hatch opening.
Step 9. Screw the 100-watt Halogen bulb into the socket.
Do not touch the glass bulb with your fingers–it is extremely
important that the glass be clean. If it is touched, or dirty,
clean carefully with a tissue. A dirty glass bulb will cause the
bulb to fail almost immediately.
INSTALLING THE GLASS
GLASS
HATCH
Step 8. Straighten the fan, then check to ensure that there
is no movement between the canopy and ceiling or Hang-Tru
ball and downrod.
Tip: Place the lock washer on the canopy screw,
and the screw through the hatch before tilting the
fan to install the hatch onto the canopy.
Step 10. Position the indentations in the
outer rim of the glass so that they line
up with the tabs on the inside surface of
the fan light fixture rim.
Step 11. Carefully lift the glass shade
up inside the light fixture as far as it
will go.
Step 12. Rotate the glass shade in a
clockwise direction until it falls into the
notch for each tab.
Step 13. Turn power back ON at the
circuit breaker or fusebox.
This completes the installation of the
fan.
IMPORTANT! When installing the halogen bulb, care-
fully cut off the end of the plastic sleeve the bulb
comes in and hold the bulb by the plastic sleeve to
screw it into the socket.
NOTE: In compliance with US Federal Energy Regula-
tions, this ceiling fan contains a device that restricts
the light kit to a maximum of 190 watts. Exceeding
that limit or the marked limit on this product may
result in a fire hazard or improper operation.
INDENTATION
FOR TAB
NOTCH
FOR TAB
MODEL AND
SERIAL NUM-
BER PLATE
St e a l t h
®
GLASS HOLDER
TABS
HALOGEN BULB
100 WATT MAX.