Filter
Top Products
3
www.chpower.com
PW1810
• Point gun in safe direction. Unit will
start spraying when trigger is
squeezed if “on/off” switch is in
“ON” position.
• Discharge pressure – When ‘on/off’
switch is in “off” position, pressure
may still exist in unit. To discharge
pressure, point gun is safe direction
and squeeze trigger.
Risk of explosion
• Do not spray flammable liquids.
• Never use in areas containing
combustible dust, liquids, or vapors.
• High pressure - Gun kicks back –
Hold gun with both hands.
• Keep hose away from sharp objects.
Bursting hoses may cause injury.
Examine hose regularly and replace
if damaged. Do not attempt to
mend a damaged hose.
• Use only detergents specifically
formulated for pressure washers.
Always follow detergent
manufacturer’s label
recommendations for proper use of
detergents. Always protect eyes,
skin, and respiratory system from
detergent.
• For either indoor or outdoor use.
Store indoors and where
temperature stays above freezing.
• Unplug unit when not in use.
• Pressure washer is not meant to
pump hot water. Do not connect to
hot water supply.
• Never leave the unit unattended
while it is plugged in.
• Always turn water supply “ON”
before turning pressure washer
“ON.” Running pump dry causes
damage.
Assembly Instructions:
1. Assemble handle by sliding handle
into unit and secure using four
enclosed screws as shown in Figures
1 and 2.
2. Slide detergent bottle “I” into left
side of unit and detergent bottle “II”
into right side of unit and attach
detergent tube to hose barb on
bottle as shown in Figures 3 and 4.
Note: After attaching detergent tubes,
make sure tubes are smooth and not
kinked.
Figure 1
Figure 2