Filter
Top Products
lock should be locked at all times
when pressure washer is not in use.
The swivel adapter comes from the
factory with 1 gasket installed on each
side. Certain garden hoses require the
use of this extra gasket to prevent water
leakage.
Power Cord
1. Plug the power cord into a
grounded 120V outlet and press the
reset button as shown in Figure 4.
2. THIS MUST BE DONE EACH TIME THE
UNIT IS PLUGGED IN AN OUTLET.
www.chpower.com
5
• Pressurewasherisnotmeanttopump
hot water. NEVER connect it to a hot
water supply as it will significantly
reduce the life of the pump.
• NEVERstorethepressurewasher
outdoors or where it could freeze. The
pump will be seriously damaged.
• Releasetriggerwhenchangingfrom
high to low pressure modes. Failure to
do so could result in damage
Keep hose away
from sharp
objects. Bursting hoses may cause
injury. Examine hoses regularly and
replace if damaged. Do not attempt
to mend a damaged hose.
Garden Hose Connection
Instructions
1. Attach swivel adapter to pump
water inlet, if not already attached.
Notice the swivel adapter is marked
with the words pump and hose.
Make sure to connect pump side
of adapter to pump water inlet to
prevent damage to the threads.
2. Attach garden hose to swivel
adapter side marked hose.
3. The spray gun should be locked into
the “OFF” position by locating the
safety trigger lock just above the
trigger of the gun. Activate the
lock by holding the gun and push
the lock from left to right. Squeeze
trigger to make sure the trigger
does not move. The safety trigger
Operating Instructions and Parts List PW1350
Figure 2 - Garden Hose Connection
Swivel
Adapter
Garden
Hose
Pump Gasket Hose Gasket
Extra Gasket
Figure 3 - Garden hose gasket instructions
Reset
Figure 4 - Grounded plug/reset button