Filter
Top Products
Page 10 2008 Portable Spa Owner’s Manual
LTR20081000, Rev. B
Operating Your Spa
Operating Your Spa
5100, 6200 and 6300
Electronic Control
Operation
Initial Start up
When rst powered up, it will automatically
revert to Priming mode. A Pr on the
topside display will indicate this. Priming
mode will be active for less than ve
minutes at which time the heater will be
activated and the water temperature will
be maintained in Standard mode. The
spa will heat to 100°F (37.5°C) at start up
until the set temperature is changed as
described below.
Temperature Adjustment
(Range 80°F to 104°F, 26°C to 40°C)
The 6200 and 6300 electronic control panels display
the actual water temperature in degrees Fahrenheit.
The displayed temperature will only be current after the
pump has been running for at least two minutes.
To display the temperature that the spa is set to:
Press the Temp button. The temperature setting will
ash.
While the display is ashing, each time you press
Temp button, the set temperature will change up or
down one degree.
If the desired temperature is opposite of the direction
each press of the button is making, release button,
allow display to stop ashing and then press Temp
button to change temperature the other direction.
Standard, Economy and Sleep Heating
Modes
Your new spa is equipped with a heating feature that
gives you complete control of the heating system.
When the spa is powered up, it will automatically start in
standard heating mode.
St will light briey on the main display. In this mode,
the heating system will automatically maintain the
set spa temperature. In the economy-heating mode,
the heating system will only activate during ltration
times.
•
•
•
•
Ec will display solid if temperature is not current
and will alternate with spa temperature if measured
temperature is current.
Economy mode will heat the water to the set
temperature while Sleep mode, indicated by a SL
on the main display, will also only activate the heater
during the ltering cycles but will only heat the
water to within 20°F (10°C) of the set temperature.
Like Economy mode, SL will display solid when
temperature is not current and will alternate with
actual temperature when it is current.
NOTE: Displayed temperature will only be current after
the pump has been running for at least two minutes.
Switching Modes
Press Temp button followed by the Light button.
Press the same sequence to switch to the next
mode.
Jets
Press the Jets button:
Once to activate low speed pump.
Twice to activate high speed.
Three times to turn pump off.
•
•
•
•
•
•
•