Filter
Top Products
1716
WARNING
Make sure you download any pictures from your camera
BEFORE you remove the batteries from the camera.
WARNING
Do NOT look directly at the sun through your spotting scope
Doing so may cause permanent eye damage.
2 AAA Batteries Required, Not Included
REMOTE SHUTTER CABLE
Whenever possible, using the included remote shutter release cable is recommended to avoid
accidentally jarring the camera when the SNAP button is pressed. Due to the high magnification
of the camera, any motion when the shutter is open can result in photos with a blurred or shaky
appearance. The remote cable is plugged into the jack on the bottom of the camera pod as shown
below. Pressing the button on the remote will then take a photo, just as if SNAP was pressed.
If the remote shutter cable is not available, you may instead
use the self-timer (as previously described in the manual)
to trip the shutter without touching or jarring the camera.
However, the timer will not allow you to take a photo at the
exact moment you choose, as the remote cable will.
FCC Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV technician for help.
The shielded interface cable must be used with the equipment in order to comply with the limits for a digital device
pursuant to Subpart B of Part 15 of FCC Rules.
78-7348 6LIM.indd 16-17 8/17/04 3:39:35 PM