Filter
Top Products
9
OPERATION GUIDE
1.
The camera is powered by two "AAA" batteries (not included) or USB power (included)
2. Insert two AAA alkaline batteries into battery compartment
3. Press and hold
MODE button until camera turns on.
4. Press
SNAP to take a picture, or press MODE button quickly to change mode
settings as described above. The camera is set at infinity and will not be focused
on an object closer than 20 feet.
5. The mode setting operation is a cycle loop, so press
MODE button to switch to
another mode. The loop order of the different modes is shown here:
6. To change settings, toggle through the different modes by pressing the MODE
button. When a mode is selected, the indicator symbol on the LCD will start
flashing. You can then select that mode by then pressing the
SNAP button.
7. When changing modes, if no buttons are pressed for 5 seconds, the camera will
return to normal mode.
8. When in "Normal" mode, press
SNAP to take a picture.
8
9. When in "Normal" mode, pressing the
MODE button will cause the camera to
enter "Mode Change."
10. To change to the "Self-Timer" mode, press
MODE once and then press SNAP to
select. The self-timer is now on. The camera will remain in this mode until you
change the mode.
11. When in "Normal" mode press MODE button twice to change
to "Repeat Shot" mode. When you see the " " icon blinking,
press
SNAP to enter this mode (the “ “ icon will stop
blinking). By pressing and holding the SNAP button you
will now be able to take 3 consecutive pictures. The camera
will remain in this mode until you change the mode or until the
camera’s memory is full. When memory is full the display will show "FUL" and an
alarm will sound.
Press MODE
Press SNAP to enter this mode
Alarm will sound
78-7348 6LIM.indd 8-9 8/17/04 3:39:32 PM