Filter
Top Products
ASSEMBLY
2387 01/11 Assembly Section 3-5
© 2011 Alamo Group Inc.
ASSEMBLY
Dismounting Loader and Mounting Loader to Tractor
Dismounting Loader
To avoid injury during installation of loader:
• Place loader bucket against barrier to restrict forward movement of loader.
• Do not permit bystanders within 10 feet of loader.
Loader must be equipped with a bucket or other optional attachment to dismount from
tractor.
When dismounting loader, maintain clearance between loader side frames and tractor hood
and front axle.
1. Locate tractor and loader on firm level ground.
2. Level and lower bucket to ground. Engage
tractor brakes and shut off tractor engine.
Move lift control lever back and forth several
times to relieve pressure in lift cylinders.
3. Remove 5/8 lock nuts and washers which
clamp hinges closed around mid mounting
tubes on tractor.
4. Start tractor engine and release tractor brakes.
Activate lift control lever to raise side frame up
off midmounting assembly. Continue rotating
loader side frames off midmounting tubes.
Slowly back tractor out of loader while rotating
loader side frames. Allow loader to roll off front
mounting bracket until lift cylinders are fully
extended and yoke is resting on ground.
Engage tractor brakes and shut off tractor
engine.
5. Move lift and bucket control levers back and
forth several times to relieve pressure on lift
and bucket cylinders. Disconnect quick
couplers between loader and tractor. Hang
hoses over loader side frame upright for
storage. Make sure male quick couplers will
not become contaminated during storage.
6. Fasten bolts, washers and nuts onto hinge for
storage.
NOTE: Loader should be stored in a dry place. If loader is being stored for an extended period (one month or
more), a coat of grease should be applied to the cylinder shafts to prevent rusting.