Filter
Top Products
11
Unpack the Mower
1. Cut all four corners of the box from top to bottom.
2. Remove all packing materials from the mower.
3. Locate and identify the items included with the
mower:
•Mulchingplug(installed)
•Grassbag
•Sidedischargedeflector
•SAE30WOil
•BatteryCharger(7800887)
•SetofKeys(7800887)
•Operator’smanual
Raise the Handle Assembly
1. Loosen, but do not remove, the knobs (A, Figure
1) on both sides of the upper handle.
2. Unfold the upper handle so that it is aligned with
the lower handle, and tighten the upper knobs.
3. Remove the handle knobs, washers and carriage
bolts from the lower handle (B).
4. Raise the lower handle, aligning it with one of the
three sets of holes in the handle bracket. (Most
users will prefer the middle position). Replace the
hardware removed in Step 3, tightening securely.
Set Up the Starter Rope Handle
1. Squeeze the blade control (A, Figure 2) against
the handle.
2. Pull the starter rope handle (B) out of the engine to
the rope guide (C). Hook the starter rope into the
rope guide (it might be a tight fit).
Figure 1: Raising the handle assembly
A
B
Figure 2: Starter rope handle
A
C
B
Assemble the Grass Bag
1. Slide the frame assembly (A, Figure 3) into the
grass bag (B). Ensure the handle (C) is on the out-
side of the grass bag.
2. Attach the clips (D) to the sides, top and bottom of
the frame assembly.
Figure 3: Assembling the grass bag
B
C
A
D
Assembly
en
Not for
Reproduction