Filter
Top Products
Features and Controls
Engine Features and Controls
For engine features and controls, please refer to the engine
operator's manual.
Snowthrower Features and Controls
3
DescriptionIconLocation
AugerControl Lever-Usedto engageand
disengage the auger and impeller. To
engage,pushdown.Todisengage,release.
A
Speed Select Lever - Allows the operator
to select forward and reverse speeds. To
shift, move speed select lever to desired
position.
NOTE: Do not move speed select lever
while Traction Control is engaged. This
mayresult inseveredamage to thedrive
system.
1
R1
R2
2
3
B
Chute Rotation Crank - In-Dash (if
equipped)- Used to rotate the discharge
chute to the left or right.
C
Chute Rotation Crank - Lefthand Crank
(ifequipped)-Used torotatethedischarge
chute to the left or right.
D
Chute Rotation Switch - Electric (if
equipped)- Used to rotate the discharge
chute to the left or right.
E
DescriptionIconLocation
Free Hand™ Control (if equipped)- After
engagingthetractioncontrol(lefthand)and
auger control (right hand), allows the
operator to release the auger control lever
to use other controls.
F
Traction Control Lever - Used to propel
snowthrowerforwardorreverse.Pushdown
to engage, release to disengage. See also,
"Free-Hand Control".
G
DeflectorControl - In-Dash(if equipped)
- Used to control the angle of the deflector
(up or down).
H
Deflector Control -Manual (if equipped)
- Used to control the angle of the deflector
(up or down).
I
DeflectorControl - Electric(if equipped)
- Used to control the angle of the deflector
(up or down).
J
Easy Turn™ Traction Control (if
equipped) - When engaged, allows the
operator to release one drive wheel, but
allows the other wheel to continue driving
for easy turning.
K
GripWarmerSwitch(if equipped)-Used
to warm the hand grips (high, off, low).
L
Clean-Out Tool-Usedto removesnowand
debris from the discharge chute and the
auger housing.
-M
Skid Shoes - Used to adjust the ground
clearance of the auger housing.
-N
8
Not for
Reproduction