Briggs & Stratton 1695985 Snow Blower User Manual


 
will continue to rotate until the traction control lever/Free
Hand control lever is released.
8. If desired, if equipped, use the grip warmer switch (L) to turn
on the heated hand grips.
Stopping the Snowthrower
1. Release the auger control lever (A, Figure 3).
2. Release the traction control lever (F).
3. Stop the engine. Please refer tothe engine operator's manual
for engine instructions.
Easy Turn™ Traction Control (if equipped)
For easyturning when using the snowthrower, squeeze the Easy
Turn traction control lever (Figure 4).
NOTE: The Easy Turn will be more difficult to activate under a
heavy load. Activate the level before beginning a turn.
4
Engaging the Easy Turn traction control lever releases one of
the traction wheels, but allows the other wheelto continue driving.
Releasing the Easy Turn traction control lever automatically
engages both drive wheels for full traction (Figure 5).
5
Wheel Release - Lock Knob (if equipped)
Some models are equippedwith a drive wheel release that allows
you to disengage one of the drive wheels, for easier transporting
of the unit with the engine off.
Models with Traction Lock Knob: Wheels equipped with a
traction lock knob (A, Figure 6) can be completely released by
pulling the knob out away from the wheel until the locking pin is
disengaged from the wheel. Then rotate the knob so the pin does
not re-engage the wheel. Reverse this process to engage the
drive wheel.
6
Wheel Release - Lock Pins (if equipped)
Wheels equipped with a traction lock pin (A, Figure 7) can be
completely released by removing the pin and installing it in the
outer axle hole. Reverse this process to engage the drive wheel.
7
10
Not for
Reproduction