Filter
Top Products
C
B
A
F
E
M
L
N
A
I
2
Installation Instructions Roller Bar Mower Kit
Figure 2. Remove Frame Hung
Components
A. Capscrew, 5/16-18 x 3/4
B. Bracket & Wheel Assembly, RH
C. Trunnion Assembly
D. Capscrews, 5/16-18 x 1-1/4
E. Arm
F. Height of Cut Plate
G. Lockwashers, 5/16
H. Nuts, 5/16-18
I. Hair Pins
J. Clevis Pins
K. Rocker Shaft Assembly
L. Locknut, 1/2-13
M. Stop, Height of Cut
N. Adjustment Rods
O. Straps
P. Bracket & Wheel Assembly, LH
Q. Locknuts, & Washers
R. Capscrews, 5/16-18 x 1-1/2
S. Chains, 4 Link
REMOVAL 54” FRAME HUNG
1. Disconnect hair pins (I, Figure 2) and clevis pins (J)
from adjustment rods (N). Remove adjustment rods
(N) from rocker arm assembly (M). Reconnect hair
pins (I) and clevis pins (J) into adjustment rods (N) to
prevent loss.
2. Remove and retain 5/16-18 x 1-1/4 capscrews (A).
Remove and bracket (B).
3. Remove and retain 5/16-18 x 1-1/4 capscrews (D),
arm (E) and crank & trunnion assembly (C). Remove
and retain nuts (H), lockwashers (G) and height of cut
plate (F).
4. Remove and retain nuts (L). Remove and discard
stop (M).
5. Remove and retain straps (O) capscrews (A).
Remove and discard rocker arm assembly (K).
6. Remove and retain 5/16-18 x 1-1/2 capscrews (R)
locknuts & washers (Q), and chains (S).
O
A
P
M
J
S
R
Q
Q
G
H
D