Filter
Top Products
Follow these instructions to change spray tips:
1. Engage safety latch on spray gun.
2. Pull back collar on quick–connect and pull current
spray tip off.
3. Select desired spray tip:
• For gentle rinse, select white 40° spray tip.
• To scour surface, select yellow 15° or red 0° spray
tip.
• To apply chemical, select black spray tip.
4. Pull back on collar, insert new spray tip and release collar.
Tug on spray tip to make sure it is securely in place.
5. For most effective cleaning, keep spray tip from 8 to
24 inches away from cleaning surface.
6. DO NOT get closer than 6 inches when cleaning
automobile tires.
Cleaning and Applying Chemical
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
To apply detergent follow these steps:
1. Review spray tip use.
2. Prepare chemical solution as required by manufacturer.
3. Pour chemical solution into chemical reservoir labeled
A or B.
NOTE: Each chemical reservoir holds two quarts.
4. Fill other chemical reservoir with a different prepared
solution, as desired.
5. Make sure black spray tip is installed.
NOTE: Detergent cannot be applied with high pressure
spray tips (White,Yellow, or Red).
6. Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray
gun and pump; start engine.
7. Rotate chemical shut-off valve on desired chemical
reservoir to “On” position (Figure 14).
8. Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
9. Allow detergent to soak in between 3–5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. DO NOT allow detergent
to dry on (prevents streaking).
Pressure Washer Rinsing
After detergent is applied, scour the surface and
rinse it clean as follows:
1. Apply safety latch to spray gun.
2. Make sure both chemical shut-off valves are in “Off”
position.
3. Remove black chemical spray tip from nozzle
extension.
4. Select and install desired high pressure spray tip, as
described in “How to Use Spray Tips”.
5. Keep spray gun a safe distance from spray surface.
6. Apply a high pressure spray to a small area and then
check the surface for damage. If no damage, proceed to
step 7.
7. Start at top of area to be rinsed, working down with
same overlapping strokes used for cleaning.
• Keep spray nozzle between 8 to 24 inches away from cleaning
surface.
• Operate this unit on a stable surface.
• Be extremely careful if you must use the pressure washer from
a ladder, scaffolding or any other relatively unstable location.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury if gun kicks back.
High pressure spray could cause you to fall if
you are too close to the cleaning surface.
WARNING
2800 PSI Pressure Washer
11
Figure 14 — Chemical Shut-Off Valves
“On” Position
“Off” Position
• Only one chemical solution should be used at a time to avoid
possible bodily injury and/or property damage.
DO NOT turn on both chemical shut-off valves at the
same time.
CAUTION