Filter
Top Products
5
3
Assembly
NOTE: Stand behind
the tiller as if you were
going to operate it. Your
right hand corresponds
to the right side of the
tiller; your left hand
corresponds to the left
side of the tiller.
IMPORTANT
This unit is shipped
without gasoline or oil
in the engine. Fill up
gasoline and oil as
instructed in the accom
-
panying engine manual
BEFORE operating your
machine.
NOTE: This operator’s
manual may cover
various models of tillers.
The units illustrated
may vary slightly from
your unit. Follow only
those instructions which
pertain to your model
number.
Assembly
1. Remove the star handle knobs and carriage bolts from
the lower handle, Figure 3-1.
Figure 3-2: Attach and secure upper handle.
Figure 3-3: Install left side of the tine clutch control.
Figure 3-4: Hook cable into tine clutch control.
Figure 3-5: Install right end of tine clutch control.
Figure 3-1: Remove hardware from lower handle.
A
B
B
2. Position the upper handle onto the lower handle, Step
A Figure 3-2. Align the holes on lower handle with the
holes on the upper handle (choose the upper or lower
holes depending on the desired handle height).
3. Insert carriage bolts through the holes and secure with
star knobs, Step B Figure 3-2. Make certain carriage
bolts are seated securely into one of the two positions
provided.
4. Insert left end of tine clutch control into the hole on the
left side of the upper handle, Figure 3-3.
5. Insert the Z-fitting on the clutch cable into the hole
on the tine clutch control. Hook the “Z” end into the
opening from the inside to the outside as shown in
Figure 3-4.
6. Squeeze the tine clutch control inward. Insert right
end into the hole on the right side of the upper handle,
Figure 3-5.