Filter
Top Products
OPERATION
TM60/72/84/100 02/11 Operation Section 4-17
© 2011 Alamo Group Inc.
OPERATION
10.3 Front Gauge Wheel Interference Check
Do not operate mower until this interference
check has been performed. If you change
tractors, you must perform the check for that
mounting.
Raise mower with tractor hydraulics to maximum
height of tractor lift.
Pivot both front gauge wheels forward and check
that there is clearance between gauge wheels
and tractor tires.
If there is interference, you must move hitch pin to
extended position (See assembly section). Move
tractor tires inward to obtain clearance or lower
mower until clearance exists. Set 3-Point
quadrant stop so mower cannot be raised beyond
set point.
• Inspect the gearbox oil level. A low oil level is a
warning sign that the gearbox may be cracked
or its seal is damaged and needs replacement.
• Ensure the gearbox vent is in place and free
from clogs. OPS-R-0040
• Inspect blades and blade bolts for looseness
and excessive wear. Make sure the mower is
securely blocked up before crawling beneath.
Replace damaged, worn, and missing blades
as complete sets to maintain rotary balance.
OPS-R-0012_B