Filter
Top Products
3. (Figure X) Keep the correct top
plate (24) filing angle line of 30°
on your file guide parallel with
your chain (file at 60° from
chain viewed from above).
4. (Figure Y) Sharpen cutters (25)
on one side of the chain first. File from the inside of each cutter to
the outside. Then turn your saw around and repeat the processes
(2,3,4) for cutters on the other side of the chain. Use a flat file to
file the tops of the
rakers (portion of chain link in
front of the cutter) so that they
are about .025 inch (.635 mm)
below the tips of the cutters.
5. (Figure Z) Keep all cutter
lengths equal.
6. If damage is present on the
chrome surface of the top
plates or side plates, file back
until such damage is
removed.
CAUTION: After filing, the cutter will be sharp, use extra caution
during this process.
NOTE: Each time the chain is sharpened, it loses some of the low
kickback qualities and extra caution should be used. It is
recommended that a chain be sharpened no more than four times.
THE RBRC™ SEAL
The RBRC™ (Rechargeable Battery Recycling
Corporation) Seal on the LI-ION battery (or battery pack)
indicates that the costs to recycle the battery (or battery
pack) at the end of its useful life have already been paid
by Black & Decker.
RBRC™ in cooperation with Black & Decker and other battery
users, has established programs in the United States to facilitate the
collection of spent LI-ION batteries. Help protect our environment and
conserve natural resources by returning the spent LI-ION battery to
an authorized Black & Decker service center or to your local retailer
for recycling. You may also contact your local recycling center for
information on where to drop off the spent battery.
RBRC™ is a
registered trademark of the Rechargeable Battery Recycling Corporation.
ACCESSORIES
Accessories are available from your local retailer or nearest
Black & Decker service center.
Replacement chain accessory number RC800
(servicepart#623382-00)
Replacement bar service part # 623381-00
WARNING: The use of accessories not recommended in this
manual may be hazardous.
SERVICE INFORMATION
All Black & Decker Service Centers are staffed with trained
personnel to provide customers with efficient and reliable power tool
service. Whether you need technical advice, repair, or genuine
factory replacement parts, contact the Black & Decker location
nearest you. To find your local service location, refer to the yellow
page directory under "Tools—Electric" or call: 1-800-544-6986 or
visit www.blackanddecker.com
.025"
Y
.025 in.
.635mm
25
Z
16
60°
X
24