Filter
Top Products
6
PREPARATION
PLEASE REFER TO DIAGRAMS (A, B, C...) AND ITEM NUMBERS (1, 2, 3...) AS NOTED THROUGHOUT MANUAL. FOR EXAMPLE,
A-1 REFERS TO ITEM 1 IN FIGURE A.
UNPACKING - (FIGURES A, A1, A2)
STEP 1:
Raise the handle section A-1 into place and secure by tightening the
two lower knobs A-2. Be careful not to pinch power cord.
CAUTION: Pinch point. To avoid being pinched, keep fingers away
from area between handles when raising.
STEP 2:
Carefully cut down the sides of the box on the opposite end of the handle
and fold the flap down as shown.
WARNING: Sharp blade. Keep
body parts away from blade.
STEP 3:
With the carton end cut open, remove the cardboard filler, charger,
accessory bag and grass bag and push the mower out of the opened
carton.
HANDLE ADJUSTMENT - (FIGURE B)
Your mower has a variable height handle adjustment feature. To adjust the handle position
to suit your height preference, use the following procedure:
1. Remove both hex nuts and flat washer B-1 on the middle part of the handlebars
using a 1/2 inch wrench. Remove the carriage bolts B-2.
2. Slide the upper handle into one of the 3 adjustment positions B-3, aligning the holes
in the upper and lower handles.
3. Insert carriage bolts and install the flat washers and hex nuts, tighten securely.
A
B
A1
A2