Filter
Top Products
8
5. Disconnect the garden hose from the
water inlet.
6. Disconnect the high pressure hose
from the high pressure outlet and drain
hose.
STORAGE
1. Store pressure washer indoors away
from areas that might freeze.
2. Do not allow high pressure hose to
become kinked.
3. Turn unit on for a few seconds until all
water is removed from the pump. Turn
off immediately.
MAINTENANCE
Clean the nozzle with the tool provided.
Remove any dirt from the spray wand
nozzle hole as shown in Figure 14 and
rinse.
Use only mild soap and damp cloth to
clean the tool. CAUTION: Never use
the pressure washer to clean itself.
IMPORTANT: To assure product
SAFETY and RELIABILITY, repairs,
maintenance and adjustment should be
performed by authorized service centers
or other qualified service personnel,
always using identical replacement parts.
ACCESSORIES
Recommended accessories for use with
your pressure washer are available from
your local dealer or authorized service
center. If you need assistance regarding
accessories, please call: 1-800-544-6986.
WARNING: The use of any accessory
not recommended for use with this
pressure washer could be hazardous.
SERVICE INFORMATION
Black & Decker offers a full network of
company-owned and authorized service
locations throughout North America. All
Black & Decker Service Centers are
staffed with trained personnel to provide
customers with efficient and reliable
power tool service.
Whether you need technical advice,
GENERAL CLEANING TIPS
• Remove the fan wand (D) from the
gun wand (H) as shown in Figure J.
• Clean the nozzle with the cleaning tool
(K). Remove any dirt from the fan wand
nozzle hole as shown in Figure K and
rinse.
• For cleaning tasks such as deck or
brick patio cleaning, limit your work area
to approximately 25 square feet at a time.
• Pre-rinse cleaning area with fresh
water.
• Use only detergents formulated for
pressure washers.
• Always test detergent in an
inconspicuous area before use.
• Begin with a wide fan nozzle spray
and adjust the pressure to the desired
spray pattern.
• The best angle for spraying water
against a cleaning surface is 45 degrees.
Spraying head on tends to cause dirt
particles to imbed in the surface. When
working on vertical surfaces, it is best to
apply detergent starting at the bottom and
working upwards which will prevent the
detergent from sliding down and causing
streaks.
SHUTDOWN
1. Depress the off switch and unplug the
cord from the outlet.
2. Turn off water at the faucet.
3. Discharge residual pressure by
pressing the trigger until no more water
comes out of the adjustable nozzle.
4. Engage the gun safety catch.
J
K
598121-00 Pressure Wash Revised 11/24/03 2:00 PM Page 8