Filter
Top Products
Part No. 890604 Form No. F021602C
Page 3 of 12
PUT OIL IN ENGINE BEFORE STARTING
Read all safety and operating instructions
before assembling or starting this unit.
890028 TKD
Check
These items should be included in your carton. If
any of these parts are missing, contact your dealer.
ASSEMBLY
PACKING CHECKLIST
Fig. 2
GENERAL SAFETY
For your safety and the safety of others, these directions should be followed:
Use of Ear Protection is recommended while
operating this machine.
Use of Eye and Breathing protection is recom-
mended when using this machine, especially in dry
and dusty conditions. Optional bag cover directs dust
toward ground, away from the operator.
·DO NOT place hands or feet inside nozzle intake opening,
near debris outlet or near any moving parts.
·DO NOT start engine without debris bag and quick discon-
nect connected firmly in place to exhaust outlet.
·DO NOT start or operate machine with debris bag zipper
open.
Check
Tamper
(TKD MODELS ONLY)
890229
QUICK DISCONNECT
·DO NOT operate during excessive vibration.
·DO NOT remove bag until engine has been turned off and has
come to a complete stop.
·DO NOT remove hose kit cap on nozzle until engine has been
turned off and has come to a complete stop.
·DO NOT operate machine with hose cap, bag or hose removed.
·DO NOT use this machine for vacuuming exclusively sand,
dust, fine dirt, rock, glass, string like material, grain, rags,
cans, metal, bark or water.
·DO NOT operate this machine on slopes greater than 20%.
·DO NOT pick up any hot or burning debris, or any toxic or
explosive material.
·DO NOT allow children to operate this equipment.
9
10
11
Do not operate this machine without first reading
owner's manual and engine manufacturer's manual.
Your Billy Goat is shipped from the factory in one carton,
completely assembled except for the upper handle, debris
bag, and bag quick disconnect.
1. ASSEMBLE Lift upper handle (item 6), remove items 8, 73, 74, & 30
from lower handle (item 27). Attach upper and lower handle as shown,
and securely tighten folding handle knobs(item 73),while holding head of
screw(item 8) firmly against upper handle.
2. UNFOLD the debris bag (item 1) and fasten bag neck to bag quick
disconnect (item 83). Attach firmly to housing exhaust (item 52) see fig. 2.
3. ATTACH bag hanger strap to bag supports (item 11), preassembled to
upper handle.
4. INSTALL tamper (item 3) in chipper hopper (see page 7)(TKD ONLY).
5. CONNECT spark plug wire.
Literature
Assembly
Literature Assy
890594
Check
Check
Connector
Quick Disconnect
890176
Check
Briggs &
Stratton
Engine
Manual
1
32
30
64
8
3
Check
890022 KD
Debris Bag