Filter
Top Products
EN - 8
Do not operate in reverse unless absolutely
necessary. Always back up slowly and look
down and behind before and while backing.
Do not carry passengers.
Disengage attachment drive when traveling
from one work area to another.
Disengage power to the auger/impeller
when snow thrower is transported or not in
use.
Use only attachments and accessories
approved by the manufacturer of the snow
thrower (such as wheel weights,
counterweights or cabs).
This product is equipped with an internal
combustion type engine. Do not use unit on
or near any unimproved, forest-covered or
brush-covered land unless exhaust system
is equipped with a spark arrester meeting
applicable local, state or federal laws. A
spark arrester, if it is used, must be
maintained in effective working order by
operator.
Never operate the snow thrower without
good visibility or light. Falling snow, fog, etc.
can reduce vision and cause an accident.
Never operate unit after or during the use of
medication, drugs or alcohol. Safe operation
requires complete and unimpaired attention
at all times.
Never allow anyone to operate this unit
when their alertness or coordination is
impaired.
Avoid sharp edges. Sharp edges can cut.
Do not throw snow any higher than
necessary.
Clearing a Clogged Discharge Chute
Hand contact with the rotating
auger/impeller inside the discharge chute is
the most common cause of injury associated
with snow throwers. Never use your hand to
clean out the discharge chute.
To clear the chute:
1. SHUT THE ENGINE OFF!
2. Wait 10 seconds to be sure the
auger/impeller blades have stopped
rotating.
3. Always use a clean-out tool, not your
hands.
Maintenance and Storage
Secure unit so it will not tip over during
maintenance.
Before cleaning, removing clogs or making
any inspections, repairs, etc., disengage
clutch(es), stop unit and engine, remove
key, allow moving parts to stop. Allow hot
parts to cool.
Make sure the equipment is in safe working
condition. Check shear bolts and other bolts
and hardware at frequent intervals for proper
tightness. If components are worn or
damaged, replace with manufacturer’s
recommended parts.
Check clutch and brake operation
frequently.
Do not change engine governor settings or
over-speed engine.
Adjust and service as required. All motion of
drive wheels and auger/impeller must stop
quickly when control levers are released.
Always maintain unit in safe operating
condition. Damaged or worn out muffler can
cause fire or explosion.
Keep unit free of ice or other debris. Clean
up oil or fuel spills.
Always keep protective structures, guards,
and panels in good repair, in place and
securely fastened. Never modify or remove
safety devices.
Never store the machine with fuel in the fuel
tank inside a building where ignition sources
are present such as hot water heaters,
space heaters or clothes dryers. Allow the
engine to cool before storing in any
enclosure or covering the unit.
Always refer to operator's manual for
important details if the snow thrower is to be
stored for an extended period.
Maintain or replace safety and instruction
labels as necessary.
Run the machine a few minutes after
throwing snow to prevent freeze-up of the
auger/impeller.