Filter
Top Products
EN - 16
6. Position scraper assembly under
housing. See
Figure 10.
• D-shaped cutout must be on the left.
• Edge must point down and forward.
• Scraper assembly bolt holes must
align with square bolt holes in auger
housing.
7. Move scraper assembly backward and
up until small lip on top of scraper blade
contacts bottom lip of housing.
8. Install bolts and nuts. Tighten nuts to
40 – 50 in-lbf. Threads must protrude
beyond the nut.
9. Return unit to operating position.
IMPORTANT: If auger paddles are pulling too
strongly or scraper blade is not clearing
completely, loosen nuts (do not remove) and
slide scraper assembly down slightly. Tighten
nuts.
Adjust Remote Chute Rotation
Cables
Model 938033
1. Move engine switch (Item 16) to OFF
position and remove key. Allow unit to
cool.
2. Open fuel and oil door (Item 22) to
access chute rotation cable adjustment
screws.
3. Loosen chute rotation cable adjustment
screws. See
Figure 11.
4. Pull cable covers to the right to remove
slack.
5. Tighten screws and close fuel and oil
door.
IMPORTANT: Remote chute rotation cables
may also be accessed from under unit by
tipping unit forward.
FOR BEST PERFORMANCE
• For complete snow removal, walk
slowly and slightly overlap each path
previously taken.
• Position discharge chute downwind
when possible.
• Do not pick up gravel and rocks. Push
down slightly on handlebar to avoid
picking up debris.
• Inspect auger before each use and
remove any accumulation / debris.
• Check oil level before each use.
• Clean unit after each use.
Figure 9
Figure 10
1. Scraper Blade Edge
1
1. Chute Rotation Cable Adjustment
Screws
1
Figure 11