Filter
Top Products
EN - 14
Remote Discharge Chute Handle
Assembly
(Item 4)
Model 938033
IMPORTANT: Always throw snow in a safe
direction, away from people and windows.
Move remote discharge chute handle forward
or backward to choose the direction to throw
snow.
If chute becomes frozen and does not turn
correctly, take unit into warm area until
controls are unfrozen.
Stop Engine
1. Release auger control bar (Item 2).
2. Turn engine switch (Item 16) to OFF
position.
3. If finished with unit, close fuel shut-off
valve
(Item 20).
MAINTENANCE
Replace Auger Paddles
Replace auger paddles when paddles are
worn down to wear indicator holes. See
Figure 5.
IMPORTANT: Always replace auger paddles
in pairs. Do not replace one paddle only.
See MAINTENANCE SCHEDULE on
page 17.
1. Move engine switch (Item 16) to OFF
position and remove key. Allow unit to
cool.
2. Tip unit back onto engine guard. Do not
tip further than engine guard allows or oil
may leak out of engine.
3. Remove six hex bolts and nuts per
paddle. Discard hardware, spacers and
paddles. See
Figure 6.
NOTICE: Do not remove center plate.
4. Position new paddles with wear indicator
holes on the left side as you face the
unit.
5. Install spacers into paddle holes and
secure paddle with new hex bolts and
nuts.
6. Tighten nuts to 50 – 90 in-lbf. Do not
overtighten.
7. When both paddles are installed, rotate
auger paddles by hand. Ensure that
paddles do not rub on housing and are
tightly attached.
8. Return unit to operating position.
9. Remove slack from auger cable. See
Adjust Auger Cable on page 15.
Figure 5
1
1
1. Wear Indicator Hole
Figure 6
1
1. Bolt and Nut Locations
2. Paddle
3. Center Plate
2
1
3