Filter
Top Products
GB - 22
RUNNERS
Runners should be adjusted as conditions require
(Figure 19).
1. Position unit on a hard, flat, smooth level surface.
2. Adjust runners by inserting a spacer of desired
thickness under center of scraper blade, loosen
runner hardware, slide runners to flat surface.
Allow 1/8 in. (3 mm) between scraper blade and
hard smooth surfaces. Allow 1-1/4 in. (30 mm)
between scraper blade and uneven or gravel
surfaces. Retighten hardware.
NOTE: Keep housing level by adjusting runners
equally.
SCRAPER BLADE
IMPORTANT: Damage to auger/impeller housing will
result if blade wears down too far.
Scraper blade is adjustable to compensate for wear.
To adjust scraper blade:
1. Tip unit back onto handlebar, support housing
and loosen nuts retaining blade.
2. Adjust runners to fully raised position (housing
closest to ground).
3. Reposition scraper blade flush with runners and
tighten lock nuts.
SHEAR BOLTS
IMPORTANT: Use only Ariens shear bolts for
replacement. Use of any other type of shear bolt may
result in severe damage to unit.
Occasionally a foreign object may enter the
auger/impeller housing and jam the auger, breaking
shear bolts (Figure 20) which secure the auger to the
shaft. This allows auger to turn freely on the shaft
preventing damage to gear drive.
For Replacement:
1. Align shear bolt holes in auger with shear bolt
holes in the shaft.
2. Drive shear bolt through hole (if shear bolt was
broken this will drive remaining part from shaft).
3. Secure shear bolt with nut.
HANDLEBAR HEIGHT
To raise or lower the handlebar:
1. Remove hair pin holding chute rod to control
assembly.
2. Place unit in service position (see Service
Position on page 19).
3. Remove bottom cover.
4. Remove top mounting bolts from the handlebars
and adjust the handlebar up or down as needed
until the handlebar mounting holes align with
holes in unit frame.
5. Secure handlebar to frame with hardware
removed in step 4 using the different hardware
locations shown in Figure 21.
SERVICE AND ADJUSTMENTS
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
Figure 19
2
1
OS0482
1.Runner
2.Runner Hardware
CAUTION: AVOID INJURY. Adjust the
attachment clutch, speed selector and
traction clutch after changing the handlebar
height. See Attachment Clutch/Brake
Adjustment on page 25, Speed Selector
Adjustment on page 25 and Traction Drive
Clutch Adjustment on page 26.
Figure 20
1.Auger
2.Shear Bolts
1
2
OS7150
2