Filter
Top Products
GB - 16
If remote wheel lock does not lock or unlock properly,
adjust or repair before operation (see REMOTE
WHEEL LOCK (926002, 003, 102, 103, 302, 303, 304)
on page 23).
Axle Lock Pin (Figure 13) (926001, 101, 504,
505)
Use the axle lock pin to lock or unlock the right or left
wheel. Lock both wheels to increase traction; unlock
one wheel to allow for easier turning of the unit.
NOTE: Unit will not drive with both wheels unlocked.
Scraper Blade
The scraper blade allows the back of the housing to
keep better contact with the surface being cleared. It
also prevents damage to the housing from normal
wear.
IMPORTANT: DO NOT allow Scraper Blade to wear
too far or Auger/Impeller housing will become
damaged.
Runners
The runners control the distance between the scraper
blade and the ground. Adjust runners equally to keep
blade level with the ground. Refer to Pre-Start on
page 17 for recommended settings.
Drift Cutters (Figure 14)
Drift cutters break up snow drifts that are taller than the
auger housing and direct the snow into the auger. Store
the drift cutters on the auger housing when not in use.
Install them as shown below so they are taller than the
snow to be cleared.
FILLING FUEL TANK
Fuel Shut-Off Valve
IMPORTANT: The fuel shut-off valve MUST be in the
closed position prior to transporting the unit.
The fuel shut-off valve has two positions:
• Closed Position: Use this position to service,
transport, or store the unit.
• Open Position: Use this position to run the unit.
To add fuel to fuel tank:
1. ALWAYS place unit in open or well-ventilated
area.
2. Stop engine and allow to cool.
3. Clean Fuel Cap and surrounding area to prevent
dirt from entering Fuel Tank.
4. Remove Cap.
Figure 13
Wheel Unlocked
Wheel Locked
Axle Lock Pin
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
Figure 14
1.Stored Position
2.Operating Position
1
2
OS7110
Figure 15
OPENCLOSED
OS7115