Filter
Top Products
GB - 15
Attachment Clutch - Right Hand Lever
Squeeze Attachment
Clutch Lever against
handlebar (1) to engage
attachment. Release
both clutch levers (2) to
disengage power and
apply brake to
attachment.
IMPORTANT: If the belt
squeals when the
attachment clutch lever
is engaged, the
attachment drive may be frozen. Immediately
release the attachment clutch lever and move
the unit into a heated area to thaw.
Ignition Switch (120V start on engine)
Key Switch has two positions:
1. “Stop” - pulled out
2. Run - pushed in
NOTE: DO NOT twist key after
it is inserted.
Ignition Switch (12V start on dash
panel)
The ignition switch is
operated by a removable key.
It has three positions:
1.Stop
2.Run
3.Start
Primer Bulb
Pushing the primer bulb in adds
fuel for easier engine start.
Refer to Starting and Shut Off.
Speed Selector
The Speed Selector controls the unit travel in
a forward or reverse direction when positioned
in notch of speed.
Forward:
(6) Fastest
(1) Slow
Reverse:
(1) Slow
(2) Fast
IMPORTANT: DO NOT
change motion from
forward to reverse with
clutch engaged.
Forward speed can be
changed without
declutching.
Choke Control Knob
1. Choke Closed position:
chokes off air to engine for
easier start.
2. Choke Open position:
allows for normal
operation.
IMPORTANT: Gradually
open choke after engine
starts.
Throttle
The throttle controls the engine
speed. To increase or decrease
the engine speed, adjust to:
1. Fast (normal or warm starts)
2. Part-Throttle
3. Slow (cold weather starts)
4. Stop (engine is off)
Electric Starter
The electric starter will start a properly choked
and cranked engine when the key is turned
(12V) or starter button (120V) is pushed. Refer
to Starting and Shut-Off.
Recoil Starter Handle
When pulled, handle will turn engine over.
IMPORTANT: DO NOT let handle snap back
against starter.
1
2
OL2691
1
2
OS1431
OS0232
1
2
3
OS1321
OS1191
1
2
6
5
4
3
2
1
1
2
OS1332
STOP
1
2
3
4
OL2720