Filter
Top Products
EN - 12
4. Remove the gear cover from top of
chute pedestal.
5. Release the lock arm on the gear
assembly with your finger and rotate the
discharge chute so it points straight
ahead.
NOTICE: Make sure alignment markers on
gear assembly are lined up when discharge
chute is pointing straight ahead.
6. Remove rubber grommet from control
panel.
7. Make sure the chute control cable is
routed between the lower handlebar and
the bottom of the control panel, insert
control assembly into slot in control
panel from below and install assembly
into nylon bushing in control panel. See
Figure 13.
8. Reinstall rubber grommet over control
assembly knob and into control panel.
1
5
3
2
OS7040
4
Figure 12
1. Mounting Holes
2. Discharge Chute
3. Chute Pedestal
4. Discharge Chute Ring
5. Mounting Hardware
Figure 13
1. Control Assembly
2. Nylon Bushing
3. Push Nut
4. Socket Extension (Optional)
5. Socket, 3/4"
1
1
2
3
2
3
4
5