Filter
Top Products
GB - 27
5. Check function of remote wheel lock. If
wheel lock does not function properly,
remove bottom cover to check cable
slack.
6. Repeat steps 2 – 4 while watching cable
to remove slack.
7. Check function of remote wheel lock. If
wheel lock does not function properly,
take the unit to Dealer for repairs.
REMOTE DEFLECTOR CONTROL
(921013, 017, 018, 020, 022, 023)
(Figure 29)
Deflector must stay in selected position while
throwing snow.
If deflector does not stay in set position:
1. Tighten nut beneath control panel to
increase pressure on deflector control.
If deflector does not follow full range of travel:
1. Push deflector remote all the way
forward.
2. Loosen adjusting nuts on cable support
bracket underneath the dash panel
(Figure 29).
3. To adjust the deflector lower:
Slide cable down. Tighten bottom nut.
4. To adjust deflector higher:
Slide cable up. Tighten top nut.
5. Check travel and repeat adjustment as
necessary.
DISCHARGE CHUTE CONTROL
(921017, 018)
(Figure 30)
If chute does not stay in position while
throwing snow or if chute does not rotate
freely, adjust the cable under the gear cover
so the chute lock fingers engage or
disengage the locking gear.
If chute does not stay in position:
Loosen the cable by loosening the rear
adjustment nut, and then tightening the
forward adjustment nut against the bracket
until the lock arm engages the gear teeth
(Figure 30).
Figure 28
1. Top Jam Nut
2. Bottom Jam Nut
3. Cable Adjuster
1
2
No Slack
OS7170
3
Figure 29
2
1
1. Adjusting Nuts
2. Cable Support Bracket
OS7175
1. Forward
Adjustment Nut
2. Rearward
Adjustment Nut
Figure 30
OS7181