Ariens 921005 - ST927LE Snow Blower User Manual


 
GB - 35
SHORT TERM
IMPORTANT: NEVER spray unit with high
pressure water or store unit outdoors.
Run with attachment clutch engaged a few
minutes after each use to free unit of any
loose or melting snow.
Close fuel shut-off valve.
Inspect unit for visible signs of wear,
breakage or damage.
Keep all nuts, bolts and screws properly
tightened and know unit is in safe working
condition.
Store unit in a cool, dry protected area.
LONG TERM
Clean unit thoroughly with mild soap and low
pressure water and lubricate (see
MAINTENANCE on page 22). Touch up all
scratched painted surfaces.
Remove weight from wheels by putting
blocks under frame or axle.
Fuel System
Gasoline left in the fuel system for extended
periods without a stabilizer will deteriorate,
resulting in gum deposits in the system.
These deposits can damage the carburetor
and the fuel hoses, filter and tank. Prevent
deposits from forming in the fuel system
during storage by adding a quality fuel
stabilizer to the fuel. Follow the
recommended mix ratio found on the fuel
stabilizer container.
To treat the fuel system for storage:
1. Add fuel stabilizer (Ariens p/n 00592900)
according to manufacturers’ instructions.
2. Run engine for at least 10 minutes after
adding stabilizer to allow it to reach the
carburetor.
NEVER store the engine with fuel in the fuel
tank inside of a building with potential
sources of ignition.
STORAGE
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
SERVICE PARTS
Order the following parts through your
Dealer:
Part No. Description
00036800 Ariens Hi-Temp Grease
(3, 3 oz. cartridges)
00592900 Fuel Stabilizer 4 oz.
21533400 Spark Plug
07200431 Impeller Belt (2)
07200111 Traction Belt
00170800 Friction Disc
52100100 Shear Bolt Kit
ACCESSORIES
See your authorized Ariens dealer to add
the additional accessories available to your
Sno-Thro.
Part No. Description
72406500 Front Weight Kit
72406900 Slicer Bar