Filter
Top Products
GB - 25
REPLACING HYDROSTATIC BELT
Remove (Figure 22)
1. Remove PTO belt (see REPLACING
PTO BELT on page 24).
2. Disconnect electric clutch connector.
3. Remove clutch stop.
4. Disconnect idler spring.
5. Remove hydrostatic belt from hydrostatic
transmission pulleys, pulley, electric
clutch, and idler.
Install (Figure 22)
1. Install hydrostatic belt on idler, electric
clutch, pulley, and hydrostatic
transmission pulleys.
2. Connect idler spring.
3. Install clutch stop.
4. Connect electric clutch connector.
5. Install PTO belt (see REPLACING PTO
BELT on page 24).
Short Term Storage
IMPORTANT: NEVER clean unit with
high-pressure water or store unit outdoors.
Remove all dirt, grease, leaves, etc. Store in
a clean dry area.
Inspect unit for signs of wear or damage.
Ensure all fasteners are properly tightened.
Long Term Storage
Follow all instructions under Short Term
Storage.
Remove and fully charge battery. Store in a
clean dry area.
Drain fuel from fuel tank.
Refer to Engine Manual for the proper engine
storage procedures.
Touch up all scratched or chipped paint
surfaces.
Figure 22
OE0051
1
1. Hydrostatic Belt
2. Hydrostatic
Transmission
Pulley
3. Electric Clutch
Connector
4. Pulley
5. Clutch Stop
6. Electric Clutch
7. Idler
8. Idler Spring
2
3
4
5
2
7
8
6
CAUTION: Use care when releasing
idler spring tension. Keep body parts
well away from idler when performing
this operation.
STORAGE